Dan’s Train Blog

When I was younger I used to go climb and play on this little ship. Many years later (around 1982) I got a picture of it. Unfortunately, I only had a cheapo camera and the boat has since collapsed.

I found the print (only 3×5 inches) and scanned it at 300 dpi optical about ten years ago. I’ve always thought she’d make a great model for a RR/Wharf scene.  

I’ve never been able to find any reference to her but she had “MARIN” faintly painted on her bow.

I think the Marin worked as a small freight and passenger ship. The main deck was very heavy construction: three layers of 2″ planking at skewed angles with asphalt and fine gravel coating on top. There was no evidence of any forward bulwark. In other photos of similar boats you see removable open rails on the forward deck.

It looked like cargo was loaded on and off the foredeck and stored as far back as the area under the main cabin. The part of the main deck covered by the upper cabin was open except for 3 or 4 support posts up the middle. One of these can be seen directly under the front of the wheelhouse.

The engine and hardware were long gone. There were indications that two cylindrical fuel tanks were mounted under the main deck on either side leaving room far a good size in-line gas/diesel engine mounted above the keel, towards the stern. She had a single screw and rudder.

There was only four feet of headroom inside the flat-bottomed hull between the frames and the deck beams under the main deck. I think she was built as a motor-boat (not converted from steam) since boilers usually had to be in the middle of the hull and there really wasn’t head room on the MARIN below the main deck.

The wheelhouse was elevated about three feet above the upper deck level. Inside, the wheelhouse had a large “shelf” across the after portion which was actually the roof of the Skipper’s cabin. The upper cabin had a small captain’s cabin forward that went full width. The remainder was undivided and had benches along the walls facing inwards.

The boat used to be about 100 feet from the water on the north shore of Bodega Bay, California. The location at Mapquest (or other map website) may be found by entering the following location: Bay Flat Rd & Whaleship Rd, Bodega Bay, CA 94923

Measurements: The yellow circle shows where I placed a story pole on the ship to aid in measuring it from the photo. It was painted white and black on the belt rail of the hull, just forward of directly below the front of the wheelhouse. It is marked in feet with the first and third feet white and the middle foot black. The middle foot also has six inches marked in alternate white/black patches (these are slightly below the resolution of the camera).

I estimate the length to be about 60 feet, beam almost 20 feet.

My son has always been totally into Thomas the Tank Engine. As a parent, Thomas is ok: stories about mild interpersonal issues between locomotives, calm music, sedate editing style. As a Model Railroader, Thomas is great stuff.

When we saw Thomas and the Jet Engine I got the idea to make a jet engine to go with his wooden Thomas set.

I used a kind of weird “fire engine/crane” car as the basis. I stripped off the parts above the deck and repainted.

Next I added a old toggle switch, some Campbell oil drums and a Verlinden resin crate.

However, the crowning piece is the “jet engine” made from an old black and white TV set electron gun.